[ANY-002]How do I replace the LED assembly?

To replace the LED assembly in the ANY-002 printer, follow these steps:

1. Power Off the Printer:
   • Ensure the printer is turned off and unplugged from the power source to avoid any risk of electric shock.
2. Open the Printer Cover:
   • Press the cover release and open the printer's top cover fully.
3. Remove the Image Drums:
   • Carefully lift each of the image drum units out of the printer and place them in a safe place away from direct sources of heat and light.
4. Locate the LED Assembly:
   • Identify the LED assembly that needs to be replaced.
5. Remove the LED Assembly:
   • Carefully disconnect any connectors attached to the LED assembly. Remove any screws or fasteners holding the LED assembly in place.
6. Install the New LED Assembly:
   • Position the new LED assembly in place and secure it with screws or fasteners. Reconnect any connectors to the new LED assembly.
7. Reinstall the Image Drums:
   • Place the image drums back into the printer in the correct order: cyan (nearest the rear), magenta, yellow, and black (nearest the front).
8. Close the Printer Cover:
   • Finally, close the top cover and press down firmly at both sides so that the cover latches closed.

→ For detailed instructions, please refer to the relevant sections of the "[ANY-002] User manual_(N)_Rev.1.0.pdf".