[ANY-JET II]What is the correct procedure for installing the ANY-JETII machine?

To install the ANY-JET II machine, follow these steps:

  1. Unpack the Equipment: The ANY-JET II is shipped in two separate modules: the printer module and the cutter module. Carefully unpack both modules.
  2. Assemble the Modules:
    • Use the two blocks provided with the equipment. Insert these blocks into the printer module using the M5 bolts included.
    • Remove the two covers attached to the left side of the cutter module.
    • Slide the printer module and cutter module together, ensuring the block fits into the holes of the cutter module. Be cautious to prevent the chiller hose at the back of the cutter module from getting caught between the modules.
  3. Level the Equipment: If the floor is not level, adjust the height using the wheels at the bottom of the modules. A 13mm spanner, included with the equipment, is required for this adjustment.
  4. Connect the Cables: Once the hardware assembly is complete, connect the necessary cables between the cutter module and the printer. These include the interface cable, printer power cable, motor power cable, and LAN cable.
  5. Power On the Equipment: After all cables are connected, turn on the equipment and check if it powers on correctly. If there are any issues, contact technical support.

→ refer to the "[ANYJET II] Quick Guide_1.0(ENG).pdf", Pages 3-6.

171 E IMPERIAL HWY LA HABRA,

CALIFORNIA, USA 90631

TEL.+1-213-889-2220

E-MAIL.  sales@anytron.com

COPYRIGHT©2024 BITEK TECHNOLOGY INC. ALL RIGHT RESERVED.


ANYTRON is Bitek Technology's .

digital label printing brand

171 E IMPERIAL HWY LA HABRA, CALIFORNIA, USA 90631

TEL. +1-213-889-2220 I  E-MAIL. sales@anytron.com

COPYRIGHT©2024 BITEK TECHNOLOGY INC. ALL RIGHT RESERVED.